Masonry Contractor in Moores Mill, AL - Brick, Block and Stone Done Right
Capstone Huntsville Concrete and Masonry is a masonry contractor working in Moores Mill, AL. We repair brick, repoint mortar, fix foundations and chimneys, and build retaining walls, block walls, paver driveways and walkways for homes here.
- Licensed and fully insured.
- Free estimates at your property.
- We respond within 1 business day.
Moores Mill homes and the ground under them
Moores Mill sits in northern Madison County, with Meridianville on the west side and Huntsville to the south, so it's a short drive from where we're based. On our jobs here we mostly see family homes, from brick-front houses in newer subdivisions to older places on bigger lots with long driveways and back yards that run downhill. The newer lots usually call for walls, walks and driveways, and the older houses call for mortar and brick repair.
Out here the ground shapes the job as much as the brick does. A lot of these lots sit on red clay that holds water, so where a yard slopes toward the house, the base and the drainage take as much of our time as the wall you'll see.
Masonry services we offer around Moores Mill
Foundation repair
When a brick front cracks in a stair-step line or doors start sticking, we find out what the ground under the house is doing before we fix anything.
Chimney repair
Chimneys take the most weather on any roof here, so we rebuild the cracked concrete top, reset loose brick and repoint washed-out joints before water reaches the attic.
Tuckpointing
When joints across a whole wall look sandy or uneven, we grind out the old mortar and fill each joint so the wall reads clean and even again.
Brick repair
A brick with its face flaking off near a downspout lets water in behind it, so we cut out the bad brick and set a matching one.
Driveway pavers
Pavers suit the longer driveways on bigger Moores Mill lots, and they last when the base under them is dug deep and packed hard first.
Retaining wall construction
Where a yard slopes toward the house, a retaining wall holds the ground back, and the gravel and drain pipe behind it keep it standing.
Masonry restoration
For a brick house that's worn all over, with stained faces, tired joints and a few cracked bricks, we plan one repair instead of patching season by season.
Fireplace installation
For a family room addition or a house that never had one, we lay the firebox, hearth and chimney so smoke goes up the flue.
Stone veneer installation
Stone veneer dresses up a plain foundation or porch on a newer house, and we set it over a drainage layer so water can't sit behind it.
Concrete block walls
Block makes good privacy, shop and garden walls on larger lots, and we lay it on a real footing with steel where the load needs it.
Foundation block wall installation
For an addition, a garage or a crawlspace house, we lay the block foundation on a footing and seal the outside before the dirt goes back.
Outdoor kitchen masonry
Back patios here get used most of the year, so we build grill islands, counters and ovens in block, brick or stone that handle the weather.
Walkway construction
A walk from the driveway to the front door needs a packed base and a slight pitch so rain runs off instead of puddling at the steps.
Brick wall installation
We build brick garden walls, mailbox columns and entry walls matched to the brick on your house, with a footing and weep holes that let trapped water out.
Stone masonry
Natural stone suits a front entry, column bases or a low yard wall, and we set each piece so it bears on the stones below it.
Brick pointing
When a few joints have washed out under a gutter or at the foot of a wall, we repoint just those spots with mortar that matches the rest.
Get a free written estimate for your Moores Mill job
We reply within one business day to set a time for me to come out. The estimate is free, done at your property and comes in writing, with no pressure and no obligation.
- Based in
- Huntsville, AL 35801
- Hours
- Mon–Fri: 6 AM–9 PM, Sat–Sun: 7 AM–9 PM
Working in Moores Mill: county permits and contractor checks
Moores Mill is an unincorporated community, so there's no town hall here and permits come from the county. The Madison County Building Inspection Department is the office we deal with for jobs here, and we check with them before we start and handle the permit when your job needs one, because the start date waits on that approval. Before you hire anyone, check two things. A contractor on a bigger job needs a state home builder license, which the questions below cover, and the state and the county require a business license from anyone doing business here for pay. We're licensed and fully insured.
We're based in Huntsville, AL, just to the south, so getting our crew and a load of block up here is a short trip. What moves your price is the size of the job, how much digging, gravel and drainage go in under and behind it, and how easy the spot is to reach with equipment. The schedule turns on the permit, the weather and when the brick or stone comes in, and the written quote I send after my visit gives you the figure for your own job. We work the same way in Harvest and the other cities around Huntsville.
What rain and settling do to masonry here
Rain is the big one. Huntsville, right next door, normally gets a little over 54 inches a year, and water that sits against a foundation or behind a wall soaks the clay, pushes on the masonry and washes out the base under pavers and walks. That's why we spend the time on gravel, drain pipe and pitch before we lay anything, because a wall or a walk is only as good as what's under and behind it.
The other thing we see is mortar trouble on brick houses, from settling cracks to old patches done with mortar harder than the brick. Hard mortar pushes the damage into the brick itself, so I match the mortar to the brick and the age of the house before we repoint anything.
How a masonry job runs when you call us in Moores Mill
From your first call to the final walk-through, here's what happens and who you'll be dealing with at each step.
Call or send a note
Call (256) 417-4326 or use the form, tell us what you're seeing and give us the address. We get back to you to set a time that works.
I look the job over
I come out myself, take photos and tell you what I see, including what the job doesn't need. You get a written estimate after the visit, so you see the price before you decide anything.
Permit check, then the work
If you go ahead, I check the permit steps for your address, and when the job needs one, work starts once it's issued. Our crew lead runs the work on site with our masons.
Walk the finished job together
When we're done, I walk the job with you and point out the base and drainage you won't see later. Satisfaction guaranteed on every job.
Questions about masonry work in Moores Mill
Do I need a Madison County permit for masonry work in Moores Mill?
You might, so ask before work starts, because Madison County requires a permit before any work to build, alter, repair or demolish a structure. Its permit list names roofing, windows, siding and electrical rather than masonry, so the inspection department is the place to confirm whether your wall, chimney or foundation job needs one. We check that for your address before we start.
How do I know if a masonry contractor needs a state license in Alabama?
A contractor needs a license from the Alabama Home Builders Licensure Board for paid work on someone else's home when the job costs more than $10,000. The license is renewed every year, it covers homes up to three floors and four units, and a licensed builder has to put the license number on the written contract. If you build or improve your own one- or two-family home for your own use, not for sale, and supervise all the work yourself, the state doesn't require you to hold that license.
What flood rules apply to building on low ground in Moores Mill?
If your lot is in a designated floodplain, you need a floodplain development permit from Madison County Public Works before any work starts there. New buildings and substantial improvements in a Special Flood Hazard Area also need a FEMA Elevation Certificate showing the building sits at the right elevation. Tell us your flood zone if you know it, and we'll plan around it.
How much does masonry work cost in Moores Mill, AL?
Your price comes from the written estimate after I see the job, because what's under and behind the masonry changes more from lot to lot here than the brick does. A wall on a slope needs more digging, gravel and drain pipe than one on flat ground, and matching brick and mortar on an older house takes more time than new work. I'll show you which part of the price is the wall and which part is the work under it.
What is the best way to keep a retaining wall from leaning in Moores Mill?
Give the water behind it somewhere to go. A wall leans when wet clay pushes on it, so we put clean gravel and a drain pipe behind it and set the base below the ground line on packed stone before the first block goes down. That part costs more up front, and it's the last thing I'd cut.
How long does it take to start a masonry job in Moores Mill?
Most jobs can start once you approve the estimate and any permit is issued, so the permit and the weather set the date more than anything else. Mortar and concrete need dry days, and a long wet stretch pushes the work back. Ask me when I'm out, and I'll tell you what's ahead of your job.
Tell us about your Moores Mill project
Send a short description and your address, so I can look into the county permit and flood steps for your lot before I come out.